5, Bosch, 16 hole, 610cc Fuel Injectors, Volvo, Ford Focus, MK2 RS, Flow Matched

Description

Brand-new
610 cc, performance, Bosch, EV-14 fuel injectors for Volvo, Ford Focus RS 2.5L turbocharged, supercharged 5 cylinder engine.
DIRECT FIT - No adapters required. No wiring required
.
Custom Balanced and Matched Sets
COMPLETE FLOW AND LATENCY DATA INCLUDED
16-hole Fuel Nozzles for Maximum Fuel Atomization
STOCK-LIKE IDLE WITH PROPER TUNING
Linear at low pulse widths
FAST REACTION TIMES
FIVEOMOTORSPORT FUEL INJECTORS
are custom-manufactured in small-quantity batches to achieve the highest quality product.
Our injectors are all-fuels rated; including gasoline (MTBE), and E-85.
The finished injectors are then flowed and inscribed with a control number.
Data is recorded for each injector. The fuel injectors are then grouped into matched sets ready for shipping.
FLOW CHART
: Each set is sold with a complete and unique flow-data chart indicating individual static flow rates at 3.0, 3.5, and 4.0 BAR.
As well as 3.0 BAR dynamic pulse testing for idle (15% duty-cycle) and 50% duty-cycle.
Along with a complete dead time off-set (latency) table. Flow matching was done with industry-standard equipment of the highest quality.
The tests were performed at varying temperatures to achieve realistic results.
Linear tuning with excellent low-end, and idle rpm.
Fiveo is the only fuel injector seller that can claim this level of technology.
We purchase direct from US manufacturers/distributors. No off-branded parts ever sold.
You receive brand new, individually packaged fuel injectors.
E85 Fuel usage
- Because of the high-H2O levels, ethanol will not rust but tends to "dry" the orifices in stainless-steel constructed fuel injectors. Customers should beware that this can be a problem with some fuel injectors and may cause a "sticking" problem. Periodic lubrication is recommended if your engine will be left without starting/running for extended periods - weeks to months - at a time.
This Bosch injector has excellent high and low pulse width response times.
These sets are very consistent and will require no more than 1% trim for easy tuning
with accurate compensation down to 0.7 ms.
(See additional specs below).
Injector type: Standard-length, EV14, 16-hole disc, saturated
Flow pattern: Cone for multi-valve engines
Flow Rate: 650 cc/min at 3 BAR
Flow Rate: 62 lbs/hr at 43.5 PSI
Resistance: 12.8 Ohms
Voltage: 8-15 Volts, Nominal 13.5 Volts
Pressure: Min. 36 PSI (2.5 bar),  Max. 130 PSI (9 bar)
Surface finish: Black composite
All Viton o-rings Included for installation.